Messages

 I will make shere the  reverse lever all the way down
and check the needle
hay maybe i have the wong size needle
ill check thanks  Mike H

it's probably something as simple as that
I will take a look and clean it thanks

hello folksI have a Juki 563
everytime I reverse to back tack I get a rats nest  on the bottom of the material
   is is it the tension in the upper machine or the lower I don't know what to do

  After a few beers that looks like my work    :o

  Nice job Mike

   How cold is it in MI.
   Well my Grandpa use to say
   ITs COLDER THAN A WHORES HART
   now that cold

    Nice shop i like your table set up.
   

    Dam you have it good
    its 6 this mooring in MI.
   Mike do you no a Don St.Croix
   he lives there in a condo and has a boat

hi Mike yes I still have the Bayliner overheated engine 2 years ago
had to put new heads on that's all 500 bucks I was back in the water

looks like I'm ready to start doing boat  tops I have a Bimini To do for a 79 Carver fly bridge
I think its a 32 photo  damn speech recognition?
I bought the press n Snap tool with all the snaps needed

and A new Eagle Hot knife                 hop ni

    Hi Folks
    Yes its been a while.
    as you can see im moveing in this slowley

    My cluchs motor was giving fits runaway you no
    So pulled the trigger and called Bob on a wenday around 2:00
    To order the new servo motor was nice talking to Bob again

    After i order it i removed the cluch motor wow its heavy
    its fell in the floor broke the pulley.
   
    Guess what the servo motor was at my house the next day
    AT 2:00  now thats service
    I had the motor on and the Machine runing by 5:00

       And did i say i have control of the Machine
       Just Love it   no more runaway  wahooo
     
        So a BIG Thanks to Bob
           Mike H
         
   

  Hi Bob How much for a servo motor with a speed dial for my 563 juki
  thanks Mike From Livonia MI.

Ive never seen one this bad dang

http://detroit.craigslist.org/mcb/boa/2981342057.html

  Thanks DBR1957
  I was wondering about useing 2 zip or just 1 long one
  the 2 zips make cents
  and i like the idea of sewing one side of the binding first

  My first time sewing zipper
  This will be one more learning curve for me
  Before i start to pattern the boat to make a new top
  and ill just reuse the zips on the new top

                  Thanks Mike H     

  Thanks June and Mike
  hears a pic of the top with the bow pocket
 
So mike your saying cut it down the middle and put the  teeth even with    the cut and then bind should i use seam tape to hold the zip in place ?   

                        Mike H 
  http://i275.photobucket.com/albums/jj300/dadhuff/SN850497.jpg

[DOT i think ill go out of my mind This Dot to that Dot the bottom Dot and top Dot Mike H]

 
     bimni top is 7 years old i want to install zip on the
     bow pockets. Shoud i cut the pocket at the seam
     then cut off 1"off the pocket and then sew zips back on

     I am going to make a new top so putting zips on the pockets
     will make the pattern job easer to take the top off and back on.

    i been watching the videos wow if i hear one more
   DOT i think ill go out of my mind
    This Dot to that Dot the bottom Dot and top Dot
                                Mike H