looking for zips

[Mike8560]

I used to do alot of repairs and additions when marine max was open  I always HD to had 8s on HD to mate upnwirh the oems. They closed down a few gears ago now  so I havnt had the problem much.

[Peppy]

I've never had to source 8's here. Any input Peppy?/Lynn/other canucks?

We don't really buy any, but I think Ennis has them. We usually replace both sides with a #10 and keep the #8. We call them American zippers actually.

[Grebo]

Yes agreed Rich, but my normal stock is....

my 10#'s are about 38mm wide & the teeth bit is 10mm. (PK)

Would you like me to send you one to check it ?

I thought Kayo sold Imperial.

Suzi

[Grebo]

I am putting an order in today so let me know ASAP...  :-*

Suzi

[fragged8]

sorry guys didnt get in till late, got problems with the new boat  ???
if it's ok i'm going to have to wait a bit on the zips until i get the
boat sorted .

[Allan]

Rich

What is the problem with the new boat??

Allan

[Mike8560]

Ya is there a pro lem with rhe motor?

[fragged8]

hiya

I'm back,
 
I don't really know if its a problem or not ? I got a noise started happening when the motor
is warmed up but it doesn't do it all the time.

As far as i can tell its coming from the oil pump, maybe/maybe not.
if it is the pump i have to take the powerhead off which isn't a huge job
just a PIA.

Just in case, I changed the oil, filter and also the water impeller this weekend
but not had much of a chance to run her up for long.
I have to wait for high tide at our club to launch and it was late on sunday.

We don't have mains water at the club so I couldn't use muffs either.

the chances of the broker paying for a pump are pretty slim, but i can
do the work so not all bad.

Snuggtopz forum is back Allan, go in via the webpage link
as the address has slightly changed.

[fragged8]

Ahh yes this thread was zips wasn't it heheh..

Peppy, Pm me your address and i'll get some merchandise
in the post :-)
I looked again at the zips and the tip about the sliders, they have a V8 stamped
on the end and the pulls are rounded, so i guess #8 then.

2 x 26" and 2 x 30" would be great if you got some ?

regards
Rich

[Peppy]

pm sent

Ahh yes this thread was zips wasn't it heheh..

Peppy, Pm me your address and i'll get some merchandise
in the post :-)
I looked again at the zips and the tip about the sliders, they have a V8 stamped
on the end and the pulls are rounded, so i guess #8 then.

2 x 26" and 2 x 30" would be great if you got some ?


regards
Rich

So thats 4 @ 36"? White or black? And you want the *#!$ yankie #8's? 

[Mike8560]

Double pulls or single?

[fragged8]

hehe i'm such a numpty..

double pull white US #8 please mate.

Many thanks
Rich