I have to go sew a ten foot bimini them pattern and sew a smaller bimini for a pontoon then a connectir between the 2 and boots i bent the frames yesterday but was short one frane. After i get thst bent s d sll done i have togo install. Uggg.
Ya, I here you bro...I'm installing an air ambulance conversion (2 person gurney) in a late model Pilatus aircraft, and part of my job is to install LED flood lights on the cargo door. I use FAA approved panel board called Kydex (ABS plastic that does not burn) for the LED mount panel and cut it TOO short on one end after I did 3 hours of riveting the mounts in place. Ugggh!!!
Fortunately after calling the Factory of the very expensive Kydex, I can use ABS bonding adhesive that plumbers use to weld the pieces together. The repair will take an hour vs buying new Kydex and re-reviting before I cover it.
Gale.
Some days its hard to get on a roll.
finished at 5 then had to go install I didn't get over till 7
(https://forum.upholster.com/proxy.php?request=http%3A%2F%2Fi782.photobucket.com%2Falbums%2Fyy102%2FMike8560%2Fth_photo1_zpsde6719ff.jpg&hash=38c2ff3ff35647df70eaaa5c948881f3) (http://s782.photobucket.com/user/Mike8560/media/photo1_zpsde6719ff.jpg.html)