This rocker had to be made, perhaps 70 + years ago. Not real big, not real small,
for springs it has two bars with three springs each bar.
Not all the original considerations are there, hence my questions.
Back then, the coils, like I said 3 on each bar, therefore 6 total springs. Tying
the coils what was done back then - three side to side jute ties and the same
from front to back? No webbing.
Question #1; So did these chairs not get the diagonal jute diagonal ties?
I know 8-way can be done on this, wondering what was original back then?
Anyway depending on your response, I will do the coil ties at a minimum 6 ties (3 front to back) and (3 side to side).
Then apply the burlap. Probably some stitching to coils.
Question 2: The frame, side to side at very front - did they usually do a small
roll edge there? I don't find any evidence like old tack markings? I could see
filling over the first top layer of burlap with rubber hair/then cotton, and then doing the muslin before applying the final fabric.
I didn't say, but the bottom is the only thing upholstered. The backrest is vertical
wood slats in a comfortable curve fashion and there is no wood lathe work done
to this frame.
For now, I will wait for your input, I trust your knowledge to get this old chair pretty much back like original.
Doyle
for springs it has two bars with three springs each bar.
Not all the original considerations are there, hence my questions.
Back then, the coils, like I said 3 on each bar, therefore 6 total springs. Tying
the coils what was done back then - three side to side jute ties and the same
from front to back? No webbing.
Question #1; So did these chairs not get the diagonal jute diagonal ties?
I know 8-way can be done on this, wondering what was original back then?
Anyway depending on your response, I will do the coil ties at a minimum 6 ties (3 front to back) and (3 side to side).
Then apply the burlap. Probably some stitching to coils.
Question 2: The frame, side to side at very front - did they usually do a small
roll edge there? I don't find any evidence like old tack markings? I could see
filling over the first top layer of burlap with rubber hair/then cotton, and then doing the muslin before applying the final fabric.
I didn't say, but the bottom is the only thing upholstered. The backrest is vertical
wood slats in a comfortable curve fashion and there is no wood lathe work done
to this frame.
For now, I will wait for your input, I trust your knowledge to get this old chair pretty much back like original.
Doyle